Installation Tips
- Minimum distance 100mm between ignition and receiver battery
- Protect ignition cable only with spiral plastic band
- Never remove sparkplug connector with mechanical aids
- Remove sparkplug connector by twist/pull movement
- Spark pug connector has to have a firm and save sit on sparkplug hexagon.
- If this is not the case; radio interference
- Use only ignition on/off switches recommended by 3W
- Battery operating voltage not below 4,8V
- Use high quality servo for throttle operation of carburettor
- Use same inside diameter for tank ventilation and carburettor fuel line
- Tank setup for engines with two carburettors:
- each craburettor has to have its own fuel-line end fels tank filter!
- both tankfilters have to bind together with gas resistent small plastic straps, when using one big tank
- in case of space problems, two small tanks can be used